/*-------------------------------------------------------------------------
 *
 * timestamp.h
 *	  Timestamp and Interval typedefs and related macros.
 *
 * Note: this file must be includable in both frontend and backend contexts.
 *
 * Portions Copyright (c) 1996-2012, PostgreSQL Global Development Group
 * Portions Copyright (c) 1994, Regents of the University of California
 *
 * src/include/datatype/timestamp.h
 *
 *-------------------------------------------------------------------------
 */
#ifndef DATATYPE_TIMESTAMP_H
#define DATATYPE_TIMESTAMP_H

#include <math.h>
#include <limits.h>
#include <float.h>

/*
 * Timestamp represents absolute time.
 *
 * Interval represents delta time. Keep track of months (and years), days,
 * and hours/minutes/seconds separately since the elapsed time spanned is
 * unknown until instantiated relative to an absolute time.
 *
 * Note that Postgres uses "time interval" to mean a bounded interval,
 * consisting of a beginning and ending time, not a time span - thomas 97/03/20
 *
 * We have two implementations, one that uses int64 values with units of
 * microseconds, and one that uses double values with units of seconds.
 *
 * TimeOffset and fsec_t are convenience typedefs for temporary variables
 * that are of different types in the two cases.  Do not use fsec_t in values
 * stored on-disk, since it is not the same size in both implementations.
 * Also, fsec_t is only meant for *fractional* seconds; beware of overflow
 * if the value you need to store could be many seconds.
 */

#ifdef HAVE_INT64_TIMESTAMP

typedef int64 Timestamp;
typedef int64 TimestampTz;
typedef int64 TimeOffset;
typedef int32 fsec_t;			/* fractional seconds (in microseconds) */
#else

typedef double Timestamp;
typedef double TimestampTz;
typedef double TimeOffset;
typedef double fsec_t;			/* fractional seconds (in seconds) */
#endif

typedef struct
{
	TimeOffset	time;			/* all time units other than days, months and
								 * years */
	int32		day;			/* days, after time for alignment */
	int32		month;			/* months and years, after time for alignment */
} Interval;


#define MAX_TIMESTAMP_PRECISION 6
#define MAX_INTERVAL_PRECISION 6

/*
 *	Round off to MAX_TIMESTAMP_PRECISION decimal places.
 *	Note: this is also used for rounding off intervals.
 */
#define TS_PREC_INV 1000000.0
#define TSROUND(j) (rint(((double) (j)) * TS_PREC_INV) / TS_PREC_INV)


/*
 * Assorted constants for datetime-related calculations
 */

#define DAYS_PER_YEAR	365.25	/* assumes leap year every four years */
#define MONTHS_PER_YEAR 12
/*
 *	DAYS_PER_MONTH is very imprecise.  The more accurate value is
 *	365.2425/12 = 30.436875, or '30 days 10:29:06'.  Right now we only
 *	return an integral number of days, but someday perhaps we should
 *	also return a 'time' value to be used as well.  ISO 8601 suggests
 *	30 days.
 */
#define DAYS_PER_MONTH	30		/* assumes exactly 30 days per month */
#define HOURS_PER_DAY	24		/* assume no daylight savings time changes */

/*
 *	This doesn't adjust for uneven daylight savings time intervals or leap
 *	seconds, and it crudely estimates leap years.  A more accurate value
 *	for days per years is 365.2422.
 */
#define SECS_PER_YEAR	(36525 * 864)	/* avoid floating-point computation */
#define SECS_PER_DAY	86400
#define SECS_PER_HOUR	3600
#define SECS_PER_MINUTE 60
#define MINS_PER_HOUR	60

#define USECS_PER_DAY	INT64CONST(86400000000)
#define USECS_PER_HOUR	INT64CONST(3600000000)
#define USECS_PER_MINUTE INT64CONST(60000000)
#define USECS_PER_SEC	INT64CONST(1000000)

/*
 * We allow numeric timezone offsets up to 15:59:59 either way from Greenwich.
 * Currently, the record holders for wackiest offsets in actual use are zones
 * Asia/Manila, at -15:56:00 until 1844, and America/Metlakatla, at +15:13:42
 * until 1867.  If we were to reject such values we would fail to dump and
 * restore old timestamptz values with these zone settings.
 */
#define MAX_TZDISP_HOUR		15	/* maximum allowed hour part */
#define TZDISP_LIMIT		((MAX_TZDISP_HOUR + 1) * SECS_PER_HOUR)

/*
 * DT_NOBEGIN represents timestamp -infinity; DT_NOEND represents +infinity
 */
#ifdef HAVE_INT64_TIMESTAMP
#define DT_NOBEGIN		(-INT64CONST(0x7fffffffffffffff) - 1)
#define DT_NOEND		(INT64CONST(0x7fffffffffffffff))
#else							/* !HAVE_INT64_TIMESTAMP */
#ifdef HUGE_VAL
#define DT_NOBEGIN		(-HUGE_VAL)
#define DT_NOEND		(HUGE_VAL)
#else
#define DT_NOBEGIN		(-DBL_MAX)
#define DT_NOEND		(DBL_MAX)
#endif
#endif   /* HAVE_INT64_TIMESTAMP */

#define TIMESTAMP_NOBEGIN(j)	\
	do {(j) = DT_NOBEGIN;} while (0)

#define TIMESTAMP_IS_NOBEGIN(j) ((j) == DT_NOBEGIN)

#define TIMESTAMP_NOEND(j)		\
	do {(j) = DT_NOEND;} while (0)

#define TIMESTAMP_IS_NOEND(j)	((j) == DT_NOEND)

#define TIMESTAMP_NOT_FINITE(j) (TIMESTAMP_IS_NOBEGIN(j) || TIMESTAMP_IS_NOEND(j))


/*
 * Julian date support.
 *
 * IS_VALID_JULIAN checks the minimum date exactly, but is a bit sloppy
 * about the maximum, since it's far enough out to not be especially
 * interesting.
 */

#define JULIAN_MINYEAR (-4713)
#define JULIAN_MINMONTH (11)
#define JULIAN_MINDAY (24)
#define JULIAN_MAXYEAR (5874898)

#define IS_VALID_JULIAN(y,m,d) \
	(((y) > JULIAN_MINYEAR \
	  || ((y) == JULIAN_MINYEAR && \
		  ((m) > JULIAN_MINMONTH \
		   || ((m) == JULIAN_MINMONTH && (d) >= JULIAN_MINDAY)))) \
	 && (y) < JULIAN_MAXYEAR)

#define JULIAN_MAX (2147483494) /* == date2j(JULIAN_MAXYEAR, 1, 1) */

/* Julian-date equivalents of Day 0 in Unix and Postgres reckoning */
#define UNIX_EPOCH_JDATE		2440588 /* == date2j(1970, 1, 1) */
#define POSTGRES_EPOCH_JDATE	2451545 /* == date2j(2000, 1, 1) */

#endif   /* DATATYPE_TIMESTAMP_H */